adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- It's believed that the main wear mechanism is adhesive under dry friction, while abrasive with water lubrication, and the friction and wear performances of the composites are greatly improved with water lubrication.
水润滑条件下复合材料的摩擦磨损性能远优于干摩擦条件下的性能.干摩擦条件下复合材料的磨损机制主要为黏着磨损，水润滑条件下则以磨粒磨损为主。 - Near the latter point, the strain velocity of adhesive friction and that of slide friction is near to be equal and friction coefficient has almost no effect to the strain velocity with slide friction.
在轧件与轧辊分离处，变形速度为零，在这点附近粘着摩擦和滑动摩擦变形速度值接近相等，摩擦系数几乎不影响滑动摩擦情况下的变形速度。 - Results show that for certain fractal dimension, the total adhesive friction coefficient reduces sharply as the normalized contact area increases.
结果表明，对于一定的分形维数，总的粘着摩擦系数随归一接触面积的增大而急剧减小。 - The adhesive wear and abrasive wear were both existed in the wear mechanism of the composite material, the friction coefficient fluctuated with time changed.
复合材料的磨损机制是黏着磨损和磨料磨损交替进行，摩擦系数随时间的变化上下波动。 - The mechanism shows hysteresis friction at low load while adhesive friction at high load.
在较低载荷时，丁腈橡胶表现为滞后摩擦，在较高载荷时，表现为粘着摩擦； - It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。 - With the increase of the concentrations of peroxide solutions, the degree of adhesive wear weakened and the friction coefficient decreased. In high concentration of peroxide solutions, the main wear mechanism of ceramic materials was corrosive wear, abrasive wear and the friction coefficient increased.
随着H202介质溶液浓度的增大，粘着作用减弱，摩擦系数减小，高浓度H202介质溶液中，Si3N4陶瓷材料的磨损以腐蚀磨损和磨粒磨损为主，摩擦系数增大。 - The results showed that for the material without graphite, the main wear mechanism was adhesive, the friction coefficient(μ) and wear rate(△ W) were larger;
结果表明：不含石墨时，材料的摩擦系数和磨损率均较大，磨损主要为粘着磨损； - Adhesive friction and Transporting Safety
附着摩擦与运输安全性 - The results show that the plow effect between friction pairs and adhesive area of friction surface could be effectively reduced with incorporation of SiC particles, which decrease the mass-loss wear of composite plating layer.
结果表明：SiC颗粒的加入能有效地降低摩擦副之间的犁沟效应及摩擦表面发生粘着的面积，从而减少镀层的磨损。